98 Installation and configuration
Figure 14
TTY or terminal modes at the local and the remote sites
Configuring the Fiber Remote Multi-IPE Interface
To configure the Fiber Remote Multi-IPE Interface using the MMI terminal,
log on, enter the password, and use appropriate MMI commands.
Before configuring the Fiber Remote Multi-IPE Interface, make sure that
the communication is established with the distant end; otherwise, the MMI
commands will not have effect at the far-end. Commands affecting the
far-end can be executed only when the far-end is communicating and the
Microlink is up.
Copyright © 2007-2009 Nortel Networks
.
Note:
The commands are not case sensitive (upper- or lower-case
letters can be used). The exception is the password, which must always
be entered in upper-case letters.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009