•
•
Copyright © 2007-2009 Nortel Networks
.
Fiber Remote Multi-IPE Interface units connection diagrams 151
—
a co-located IPE Module indicated by the Controller Card, the
backplane, and the I/O panel
—
three SUPERLOOP connections to the Fiber Remote Multi-IPE
Interface unit
—
connections to the SDI Paddleboard and other SDI cards as an
alternative
—
the system monitor, the fiber-optic link, and the MMI terminal
Figure 16 "Local site multiple Fiber Remote Multi-IPE Interface units
cable connection diagram" (page 153)
Multi-IPE Interface unit connections, including:
—
connections to the SDI Paddleboard and other SDI cards as an
alternative
—
system monitor connection
—
MMI terminal connection
Figure 17 "Remote site single Fiber Remote Multi-IPE Interface unit
cable connection diagram" (page 154)
two Remote IPE Modules:
—
Each Remote IPE Module is designated with a Controller Card, the
backplane connectors, and the I/O panel connectors.
—
Shows three SUPERLOOPS, which are extended from the local
site. Refer to
Figure 15 "Local site single Fiber Remote Multi-IPE
Interface unit cable connection diagram" (page
SUPERLOOP #1 supports one entire IPE Module, SUPERLOOP
# 2 and SUPERLOOP #3 support the second IPE Module.
SUPERLOOP #4 is not equipped in this example.
—
Shows the MMI terminal connection, the system monitor
connection, and the fiber-optic link connection.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
shows multiple Fiber Remote
shows the Remote IPE site with
152), where