Nortel Communication Server 1000 Series Manual page 55

The daughterboard types are:
•
•
To install the daughterboard, follow the steps in
daughterboard for the fiber-optic link" (page
Procedure 5
Installing the daughterboard for the fiber-optic link
Step
1
2
3
4
5
6
7
Copyright © 2007-2009 Nortel Networks
.
Redundant Option for single-mode fiber
Redundant Option for multi-mode fiber
Action
Remove the two filler plugs on the Fiber Remote Multi-IPE
Interface faceplate labeled XMIT B and RCV B.
Note: The Fiber Remote Multi-IPE Interface mother board
has already been exposed during switch setting procedure.
Locate four screw holes near the top left-hand corner of the
motherboard.
Insert the fiber-optic ST-type connectors into the openings on the
faceplate and install the daughterboard onto the four standoffs.
Tighten the four screws into the standoffs to secure the
daughterboard.
Hand tighten the nuts onto the ST connectors. Do not
overtighten.
Plug the ribbon cable from the daughterboard to the connector
on the motherboard.
Close the Fiber Remote Multi-IPE Interface unit by pushing
faceplate in until is flush with the front of the enclosure and no
slack is in the ejector tabs.
Install the Fiber Remote Multi-IPE Interface unit into the
rack-mounted shelf or onto the wall, as shown in
Fiber Remote Multi-IPE Interface unit installation methods" (page
58) and Figure 9 "Wall-mounting the Fiber Remote Multi-IPE
Interface unit" (page
Figure 7 "Installing the redundant fiber-optic link option" (page
56) shows the installation of the daughterboard onto the
motherboard of the Fiber Remote Multi-IPE Interface unit.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
Fiber-optic equipment installation 55
Procedure 5 "Installing the
55).
60).
Figure 8 "The