3
Connecting the MMI terminal using a modem:
Step
1
2
3
Connecting the MMI terminal to multiple Fiber Remote Multi-IPE
Interface units
Make sure that all the Fiber Remote Multi-IPE Interface units are properly
configured for the daisy-chain addressing, as shown in
Remote Multi-IPE Interface configuration" (page
To connect multiple (in this example we have 3 units) Fiber Remote
Multi-IPE Interface units in a daisy-chain configuration, refer to
11 "Daisy-chaining of multiple Fiber Remote Multi-IPE Interface units"
(page 68)
25 "Connecting multiple Fiber Remote Multi-IPE Interface units in a
daisy-chain configuration" (page
Procedure 25
Connecting multiple Fiber Remote Multi-IPE Interface units in a daisy-chain
configuration
Step
1
2
Copyright © 2007-2009 Nortel Networks
.
Plug the DB-25 male connector of the NT7R66BA MMI Cable
into the DB-25 female connector on the MMI terminal. If the
MMI terminal does not have a DB-25 connector or is a different
gender, use an appropriate adapter.
Action
Use the NT7R66AA SDI Cable Kit to connect the DB-9 female
MODEM connector on the Fiber Remote Multi-IPE Interface unit
to the modem connector.
Plug the DB-9 male connector of the NT7R66AA SDI Cable Kit
into the Fiber Remote Multi-IPE Interface DB-9 female MODEM
connector.
Plug the other end of the cable into the modem connector.
(ignore the SDI connection). Follow the steps in
Action
Plug the DB-9 female connector on the A0634497 Maintenance
Interface cable into the DB-9 male MAINT connector on the Fiber
Remote Multi-IPE Interface unit #1.
Plug the other end of the A0634497 Maintenance Interface cable
into the SDI connector on the Fiber Remote Multi-IPE Interface
unit #2.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
Remote IPE installation 85
--End--
--End--
49).
85).
Table 9 "Fiber
Figure
Procedure