Nortel Communication Server 1000 Series Manual page 66

66 Installation and configuration
3
Connecting the SDI card and the MMI terminal to multiple Fiber Remote
Multi-IPE Interface units
Make sure that all the Fiber Remote Multi-IPE Interface units are properly
configured for the daisy-chain addressing as shown in
Remote Multi-IPE Interface configuration" (page
16 "Local site multiple Fiber Remote Multi-IPE Interface units cable
connection diagram" (page 153)
To connect multiple (this example has 3 units) Fiber Remote Multi-IPE
Interface units in a daisy-chain configuration, connect the cables, as shown
in Figure 11 "Daisy-chaining of multiple Fiber Remote Multi-IPE Interface
units" (page 68)
Procedure 15
Connecting the SDI card and the MMI terminal to multiple Fiber Remote
Multi-IPE Interface units
Step
1
2
3
4
Copyright © 2007-2009 Nortel Networks
.
Plug the DB-9 male connector of the NT7R66AA SDI Cable Kit
into the DB-9 female connector on the Fiber Remote Multi-IPE
Interface unit I/O panel.
Note: For additional information about types of SDI cards,
their SDI ports, and special cables required to connect these
ports, refer to Circuit Card Reference (NN43001-311) () .
Note:
For maintenance convenience, use the daisy-chain addressing
in descending order from the MMI terminal side to the host SDI side.
Action
Plug the DB-9 male connector of the NT7R66AA SDI Cable Kit
into the SDI port DB-9 female connector on the Fiber Remote
Multi-IPE Interface unit #1.
Connect the Fiber Remote Multi-IPE Interface unit #1 to the SDI
card in the local system as explained in
to a single FiberRemote Multi-IPE Interface unit" (page
Plug the A0634497 Maintenance Interface cable into the DB-9
male MAINT connector on the Fiber Remote Multi-IPE Interface
unit #1.
Plug the other end of the A0634497 Maintenance Interface
cable into the DB-9 female SDI connector on the Fiber Remote
Multi-IPE Interface unit #2.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
--End--
49). Refer to
for the connection diagram.
"Connecting the SDI port
Table 9 "Fiber
Figure
65).