Nortel Communication Server 1000 Series Manual page 20

20 Product description
shelf is normally used at the local site where there can be a number of
Fiber Remote Multi-IPE Interface units supporting several Remote IPE
sites.
The Fiber Remote Multi-IPE Interface unit has a faceplate that contains the
ST-type fiber-optic connectors and the alarm and power LED indicators. At
the rear of the unit an I/O panel contains connectors that connect the Fiber
Remote Multi-IPE Interface unit to the local and the Remote IPE I/O panel
connectors.
Figure 3 "Fiber Remote Multi-IPE Interface faceplate" (page 21)
the front view of the Fiber Remote Multi-IPE Interface unit. It shows
primary and redundant fiber-optic connectors to support a redundant
fiber-optic link. It also shows the power and alarm indicator LEDs. The
ejector tabs are used to eject the card. The motherboard can then be
accessed to install the daughterboard or to set configuration switches.
Copyright © 2007-2009 Nortel Networks
.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
illustrates