100 Installation and configuration
To display the far-end (distant) current Fiber Remote Multi-IPE
Interface configuration:
To change the fiber-optic link alarm threshold, execute the S A command
on the MMI terminal. This sets the bit error per minute alarm threshold for
the link.
To configure the fiber-opticlink alarm thresholds:
To configure site name, time, and date:
Copyright © 2007-2009 Nortel Networks
.
FII::> D C D
Distant End Ready
Distant Configuration
Enter 'S' to Cancel Function
D C
Fiber Remote IPE S/N 2502-R3 Software Version 3.11 5/15/96 10:45
Remote Site
Alarm Enabled: YES Self Clearing Enabled: YES
Remote XSM Address 0X00
Current Fiber Alarm Threshold Value E-9
Current Dip Switch Settings (S1...S8) ON ON OFF OFF OFF OFF OFF
OFF
2400 Baud Single Terminal Mode Multidrop Address 0
FII::> S A
Alarm Threshold: Current Value E-9 New Value E-10
Alarm Threshold – Number of bit errors per minute. E-6 represents 10-6
or 1 error in 1 million bits or 3000 error bits/min, E-7 represents 10-7 or 1
error in 10,000,000 bits or 300 error bits/min, E-8 represents 10-8 or 1
error in 100,000,000 bits or 30 error bits/min, E-9 represents 10-9 or 1
error in 1,000,000,000 bits or 3 error bits/min, and E-10 represents 10-10
or 1 error in 10,000,000,000 bits or 1error bits/min.
FII:: >
FII::> S N
Change Site Name (YES or NO) Y
Enter Site Name = SC
Change Link Identifiers (YES or NO)
Y
ID for Superloop 1 004 1
ID for Superloop 2 008 1
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
Prompt requesting an MMI
command
Set name
To change the site name
New site name
To change link IDs
Superloop and shelf number
Superloop and shelf number