Nortel Communication Server 1000 Series Manual page 90

90 Installation and configuration
Table 15
Factory default parameter settings (cont'd.)
Parameter
Name
Alarm Enable/Disable
Alarm Self-Clearing Enable/Disable
Bit Error Alarm Threshold
Configuring the cards
When the Remote IPE equipment is first installed, it is necessary to define
theNT8D01 Peripheral Controller cardsNT8D01 Peripheral Controller cards
dedicated to Remote IPE support.
To do this:
•
•
•
•
Before defining a superloop for Remote IPE, it is necessary to find
available superloops in the system. To do this, logon and print system
configuration data using Print Program LD 22.
Copyright © 2007-2009 Nortel Networks
.
print the current system configuration record to identify possible
available superloops
remove an existing superloop data block if it already exists for a
superloop that is not dedicated to the Remote IPE
Note:
To remove superloop data blocks, remove all terminal
numbers (TNs) associated with the peripheral controller, disable the
superloop, and remove the data block associated with the peripheral
controller. You can also move data blocks of one superloop to a
different superloop number using Move Data Blocks Program LD 25.
configure a superloop data block to correspond to the Superloop
Network card dedicated to the Remote IPE
configure a peripheral controller data block to correspond to the
Peripheral Controller card in the Remote IPE
Table 16
Request CFN printout
Prompt Response
REQ PRT
TYPE CEQU
PKG PSWV
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
Default setting
Fiber
Enable
Enable
10 -10
Description
Print request
Configuration data