Nortel Communication Server 1000 Series Manual page 72

72 Installation and configuration
7
8
9
Figure 12 "DC power connection of the Fiber Remote Multi-IPE Interface
unit" (page 73)
Interface unit to the local DC power source.
Copyright © 2007-2009 Nortel Networks
.
Observe the POWER LED on the Fiber Remote Multi-IPE
Interface unit faceplate.
This green LED should turn ON and stay lit as long as the unit
is powered.
Push the ALARM CLEAR button to clear the alarms.
The alarms clear only if both the local and the remote Fiber
Remote Multi-IPE Interface units are connected to the fiber-optic
link and are communicating.
If POWER LED does not light, check the connection to the DC
power source, the power source, and the Fiber Remote Multi-IPE
Interface unit POWER connector.
Correct the problem.
shows the power connection of the Fiber Remote Multi-IPE
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
--End--