Nortel Communication Server 1000 Series Manual page 94

94 Installation and configuration
Selecting the MMI terminal modes
The MMI terminal can be set in the Host SDI or the MMI mode. When the
MMI terminal is in the SDI mode, system administration can be performed
tasks from the local or the remote site. When the MMI terminal is in the
MMI mode, the following tasks can be performed:
•
•
•
•
•
Selecting the MMI mode
In the MMI mode, one terminal is connected to the MMI port at the local
Fiber Remote Multi-IPE Interface unit. Another terminal is connected to the
MMI port at the Fiber Remote Multi-IPE Interface unit at the remote site.
Each terminal can control MMI functions at the local site and at the distant
site (across the fiber-optic link). In a daisy-chain configuration, an MMI
terminal can access any Fiber Remote Multi-IPE Interface unit in the chain
at the local or remote site.
The default MMI interface characteristics are configured in the Fiber
Remote Multi-IPE Interface unit as follows:
•
•
•
•
Logging in. The MMI mode is accessed from the initial (INIT) mode by
entering L or LOGIN on the terminal to log in. For multiple Fiber Remote
Multi-IPE Interface units connected in a daisy-chain, to log in to the
specified Fiber Remote Multi-IPE Interface, enter L <xx>, where xx is the
address of a specific Fiber Remote Multi-IPE Interface unit in the chain.
Refer to
address selection table" (page
Entering password. After logging in, the password is prompted. The
password is FIBER and it must be entered in all capital (upper-case)
letters.
Copyright © 2007-2009 Nortel Networks
.
perform Fiber Remote Multi-IPE Interface functions such as display
status, logs, performance information, history, and messages
enable or disable alarms
clear errors and logs
set performance parameters
specify tests
speed: 2400 bps
character width: 7 bits
parity bit: mark
stop bit: 1
Note:
This is a single user system. That is, only one terminal can be
active on the system at the time.
Table 10 "Fiber Remote Multi-IPE Interface and system monitor
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 03.01
11 May 2009
50).