Jog Trial Run Without Load - Delta ASDA-B3 Series User Manual

Test Operation and Panel Display

4.5.3 JOG trial run without load

It is easy to test the motor and servo drive using a JOG trial run without load since no extra wiring
is needed. For safety reasons, it is recommended that you set JOG at low speed. Follow these
4
steps:
Step 1: JOG trial run is available only when the servo drive is in the Servo On state. The drive can
be forced into the Servo On state by setting P2.030 to 1 or with the controller. JOG trial
run with panel operation is not available in the Communication mode (P1.001.X = B or C).
Step 2: set the JOG speed (unit: rpm) with P4.005. Press the SET key to display the JOG
speed. The default is 20 rpm.
Step 3: press the ▲ or ▼ key to adjust the JOG speed. In the following example, the speed is
set to 100 rpm.
Step 4: press the SET key to save the setting value, and then the panel displays "JOG" and
enters JOG mode.
Step 5: press the MODE key to exit JOG mode after completing the trial run.
4-18
SET
SET
JOG mode
P (CCW) N (CW)
MODE
Press the MODE key to exit JOG mode.
Exit
Displays JOG speed.
Its default value is 20 rpm.
Press the keys to adjust
the JOG speed.
Adjust the speed to 100 rpm.
Displays JOG and enters JOG mode.
After entering JOG mode, press the
or key to make the motor run in
counterclockwise or clockwise
direction. Release the key to stop
the operation.
ASDA-B3