Jog Trial Run Without Load - Delta ASDA-B3 Series User Manual

Test Operation and Panel Display

4.5.3 JOG trial run without load

It is easy to test the motor and servo drive using a JOG trial run without load since no extra wiring
is needed. For safety reasons, it is recommended to set JOG at low speed. Follow these steps:
4
Step 1: JOG trial run is available only when the servo drive is in the Servo On state. The drive
can be forced into the Servo On state by setting P2.030 to 1 or with the host controller.
(JOG trial run with panel operation is not available in the Communication mode.)
Step 2: set JOG speed (unit: rpm) with P4.005. Press the SET key to display the JOG speed.
The default is 20 rpm.
Step 3: press the ▲ or ▼ key to adjust the JOG speed. In the following example, the speed is
set to 100 rpm.
Step 4: press the SET key to display JOG and enter JOG mode.
Step 5: press the MODE key after completing the trial run to exit JOG mode.
4-18
SET
SET
JOG mode
P (CCW) N (CW)
Press the MODE key to
MODE
exit JOG mode.
Exit
Display JOG speed.
Its default value is 20 rpm.
Press the keys to adjust
the JOG speed.
Adjust the speed to 100 rpm.
Display JOG and enter JOG mode.
After entering JOG mode, press the
or key to make the motor run in
counterclockwise or clockwise
direction. Release the key to stop
the operation.
ASDA-B3