Overview Of The Pr Procedure - Delta ASDA-B3 Series User Manual

Motion Control

7.1.4 Overview of the PR procedure

In the PR mode, there are six types of commands. To make users understand how the PR
procedure works, ASDA-Soft presents the execution order and calling sequence of all PR
7
procedures. The symbols and contents in the PR diagram are shown as follows. This includes
five parts: number, command execution type (property), command type, next procedure
command, and command information. See Figure 7.1.4.1.
Number: the PR path number, ranging from PR#0 to PR#99 (100 sets of PR paths).
(1)
Command execution type (property): (B) execute homing when power on; (O) command
(2)
overlap; (R) write data to EEPROM; and (I) command interrupt.
Command type: there are six types of PR procedure commands: Homing, Speed, Position,
(3)
Jump, Write, and Rotary Axis Position (Index Position). The color displayed in this section
depends on the command type.
Next procedure command: if the current path is followed by a PR command, there would
(4)
be an arrow pointing to the specified PR path.
Command information: displays the details of this PR path. The displayed contents and
(5)
color depend on the command type.
7-36
Figure 7.1.4.1 Overview of the PR procedure
ASDA-B3