Removing And Replacing The Server Cover; Nortel Callpilot; 1005R Server Maintenance And Diagnostics; Nn44200-704 01.06 Standard - Nortel CallPilot User Manual

2

Removing and replacing the server cover

Remove the server cover if you must service the interior of the server.
Blue tab
Green tab
Black tab
To remove the server cover
Step
1
2
3
4
Copyright © 2007, Nortel Networks
.
Tighten the captive screws.
Note: If a component has a:
Power down the server before replacing it.
It can be replaced while the server is powered on.
It is non-replaceable, or not important.
Action
DANGER
Risk of electric shock
High current inside the chassis can cause severe injury.
CAUTION
Risk of equipment damage
Take precautions to protect internal components. Electrostatic
discharge (ESD) can damage boards and make them unusable.
Power down the server, unplug all peripheral devices and Ethernet
cables, and disconnect the AC power.
Turn off all peripheral devices connected to the server.
Attach the ESD strap to your wrist and attach the other end to a
known grounded connection.
While holding the blue button at the top of the chassis in, slide the
top cover back until it stops.

Nortel CallPilot

1005r Server Maintenance and Diagnostics

NN44200-704 01.06 Standard

5.0 19 July 2007
Removing and replacing the server cover 75
—End—