Verifying The Raid Firmware; Nortel Callpilot; 1005R Server Maintenance And Diagnostics; Nn44200-704 01.06 Standard - Nortel CallPilot User Manual

96 Chapter 9 RAID operations
•
•
Verifying the RAID firmware
You require the following minimum RAID firmware version:
•
To verify the RAID firmware version
Step
To determine what the current RAID firmware version is on the RAID
LSI320-1 controller, use either of the following procedures:
Press Ctrl+M
1
2
3
Step
Launch MegaRAID Power Console Plus
1
2
Copyright © 2007, Nortel Networks
.
performing RAID splitting
synchronizing RAID after installing CallPilot software upgrades (PEPs)
— Resynchronizing RAID if the installation is successful
— Resynchronizing RAID if the installation is not successful
WARNING
Nortel strongly recommends that you do not perform low level
formatting. Performing low level formatting results in the drives
becoming unusable.
1L37
Action
Turn on the server and press Ctrl+M when prompted during system
bootup.
Note: The Ctrl+M utility can take up to 1 minute to launch with
1L37 firmware. The system can appear frozen. Do not reset.
Select Objects menu → Adapter → Other Adapter Information.
Review the information on the screen. The LSI320-1 controller
firmware must be 1L37.
Action
Launch the MegaRAID client by clicking Start > Programs> Power
Console Plus > Launch Client.
From the MegaRAID Power Console Plus - Server Selection window,
select Access Mode > Full Access to view or change configuration
information and click OK.

Nortel CallPilot

1005r Server Maintenance and Diagnostics

NN44200-704 01.06 Standard

5.0 19 July 2007
—End—