Nortel CallPilot User Manual page 109

14
15
16
17
18
19
20
21
22
23
Copyright © 2007, Nortel Networks
.
Reconnect the DS30X cable or cables to the MPB96 card or cards.
You must reconnect each cable to the same MPB96 card it was
previously connected to. Use the labels you applied.
Hold the PCI riser assembly by the two blue handles (A) and
push the assembly into the server board. Refer to
assembly" (page 107).
Line up the two grooves on the back lip of the PCI riser assembly
with the pins on the rear panel as shown in the following illustration.
If the PCI riser assembly is not fully seated, the server can malfunction.
PCI riser assembly rear grooves
Reconnect the PCI riser assembly power cord.
Reconnect the SCSI cable to the RAID card.
Replace the chassis cover.
Take the ESD strap off.
Power up the server and log on to Windows.
Result: The Windows New Hardware Found Wizard screen appears.
Click Next.
Select the presented driver.
Nortel CallPilot
1005r Server Maintenance and Diagnostics
NN44200-704 01.06 Standard
5.0 19 July 2007
Replacing the RAID card 109
ATTENTION
"PCI riser card