Removing The Front Bezel And Server Cover - Nortel CallPilot 1002rp Installation And Configuration Manual

Replacing basic chassis components

Removing the front bezel and server cover

Introduction
If the maintenance task requires replacing front panel components, you must
remove the front bezel. The exception is the hard drives, which can be
accessed by simply unlocking and opening the front bezel doors.
If you require access to the server interior, remove both the front bezel and
the server cover.
To remove the front bezel, see page 123.
To remove the server cover, see page 124.
To replace the front bezel, see page 125.
Requirements
Before removing the front bezel and server cover, gather the following tools:
the customer's chassis keys for the front bezel doors
flat-blade screwdriver
antistatic wrist strap
About the front bezel doors
Two locked doors on the front of the server cover the front panel, including
the CD-ROM drive and tape drive.
These doors are part of the front bezel, which covers the front of the server.
You must unlock the front panel doors before you can remove the front
bezel.
122
Standard 1.0
CallPilot