24
25
Replacing the DVD combo drive
The DVD combo drive is not hot-swappable. You must power down the
system to replace the DVD combo drive.
Requirements
You need a Phillips (cross head) screwdriver, #1 and #2 bit.
To replace the DVD combo drive
Step
1
2
3
4
5
Copyright © 2007, Nortel Networks
.
Run the Configuration Wizard to detect the new hardware.
For instructions, see the Installation and Configuration Task List
(NN44200-306).
Result: The board replacement is complete.
Test the system to ensure the new board is functioning properly.
For instructions, see "Testing the CallPilot installation" in the
Installation and Configuration Task List (NN44200-306).
Action
Power down the server, unplug all peripheral devices and Ethernet
cables, and disconnect the AC power.
Remove the front bezel. Refer to
bezel" (page
73).
Attach the ESD strap to your wrist and attach the other end to a
known grounded connection.
Remove the chassis cover. Refer to
server cover" (page 75)
Pull out on the drive carrier handle (A) as shown in the following
diagram.
Nortel CallPilot
1005r Server Maintenance and Diagnostics
NN44200-704 01.06 Standard
5.0 19 July 2007
Replacing the DVD combo drive 89
—End—
"Removing and replacing the front
"Removing and replacing the
for instructions.