Nortel CallPilot User Manual page 34

34 Chapter 4 Using Windows online diagnostic tools
tracert [-d] [-h maximum_hops] [-j host_list]
Tracert parameters
The following table shows the tracert parameters.
Tracert parameters
Parameter
-d
-h maximum_hops
-j host-list
-w timeout
target_name
To run the tracert command from Windows
Step
1
2
3
4
The arp command
The arp command displays and modifies the IP-to-physical address
translation tables used by Address Resolution Protocol (ARP).
ARP command syntax
The ARP command uses the following syntax:
Copyright © 2007, Nortel Networks
.
[-w timeout] [target_name]
Action
Click Start > Programs > Accessories > Command Prompt.
Result: The Command Prompt dialog box appears.
Type the following command:
tracert [-d] [-h maximum_hops] [-j host_list] [-w
timeout] [target_name]
Example: tracert 200.286.0.32
Press Enter.
Result: The system runs the tracert utility.
Type Exit to exit the Command Prompt dialog box and return to
Windows.
Nortel CallPilot
1005r Server Maintenance and Diagnostics
NN44200-704 01.06 Standard
5.0 19 July 2007
Description
Specifies not to resolve addresses to host
names.
Specifies the maximum number of hops to
search for the target.
Specifies a loose source route along the host
list.
Waits the number of milliseconds specified by
the timeout for each reply.
Specifies the name of the target host.
—End—