Nortel CallPilot User Manual page 22

22 Chapter 3 Troubleshooting your CallPilot system
Error message
CMOS Display Type Wrong
CMOS Checksum Bad
CMOS Settings Wrong
CMOS Date/Time Not Set
DMA Error
FDC Failure
HDC Failure
Checking NVRAM....
Update OK!
Updated Failed
Keyboard Error
KB/Interface Error
Memory Size Decreased
Memory Size Increased
Copyright © 2007, Nortel Networks
.
Nortel CallPilot
1005r Server Maintenance and Diagnostics
NN44200-704 01.06 Standard
5.0 19 July 2007
Description
The display type is different from that
stored in CMOS. Check Setup to
make sure the type is correct
The CMOS checksum is incorrect.
CMOS memory can be corrupted.
Run Setup to reset the values.
The CMOS values are not the same
as the last boot. Either these values
are corrupted or the battery failed.
The time or date values stored in
CMOS are invalid. Run Setup to set
the correct values.
An error occurred during the
read/write test of the DMA (Direct
Memory Access) controller.
An FDC Failure error occurred while
trying to access the diskette drive
controller.
An error occurred trying to access the
hard disk controller.
The NVRAM (Non-Volatile Random
Access Memory) is being checked to
see if it is valid.
The NVRAM is invalid and has been
updated.
The NVRAM is invalid and cannot be
updated.
An error in the keyboard connection.
Make sure the keyboard is connected
properly.
The keyboard interface test failed.
The memory size has decreased since
the last boot. If you have not removed
any memory, then the memory can be
faulty.
The memory size has increased since
the last boot. If you have not added
any memory, there is a problem with
the system.