Locating The Voice Processing Boards; Dsp Numbering And Location; Nortel Callpilot; 1005R Server Maintenance And Diagnostics - Nortel CallPilot User Manual

112 Chapter 10 Replacing or adding voice processing boards
•
•

Locating the voice processing boards

"1005r server rear panel" (page 112)
server with the three full-height PCI card slots (C). The MPB96 voice
processing boards occupy one or three full-height slots. In the following
diagram, the card slots are numbered from 1 to 3 starting at the top.
1005r server rear panel
Refer to the 1005r Server Hardware Installation (NN44200-308) guide to
identify the other features on the 1005r rear panel.

DSP numbering and location

DSPs are the built-in voice processing components on MPB boards. DSPs
are numbered to distinguish them in CallPilot maintenance programs, such
as the Maintenance screen in CallPilot Manager. Each DSP supports up to
eight multimedia channels.
DSP numbering MPB96 boards
The MPB96 board has 12 embedded DSPs. MPC-8 cards are not required.
If an embedded DSP is faulty, you must replace the entire MPB96 board.
Copyright © 2007, Nortel Networks
.
Do not drop and leave screws inside the server.
Do not drop hard objects (such as screwdrivers) inside the server as
this can damage the server.

Nortel CallPilot

1005r Server Maintenance and Diagnostics

NN44200-704 01.06 Standard

5.0 19 July 2007
shows the rear panel of the 1005r