Nortel CallPilot User Manual page 118

118 Chapter 10 Replacing or adding voice processing boards
12
13
14
15
16
17
Copyright © 2007, Nortel Networks
.
Remove the rear retention screw (B) as shown in the previous
diagram.
Replace the card and tighten the screws. Make sure the red power
cable to the full-size PCI riser card is not pinched.
Reconnect the 3-drop CT bus cable (high capacity configuration
only).
Turn the PCI riser card right-side up.
Arrange the PCI riser assembly short red power cable inside the
riser assembly as shown in the following illustration to avoid pinching
the cable when you put the riser assembly into the chassis.
Full-size PCI riser card red power cable
Arrange the PCI riser assembly power cable as shown in the
following illustration.
Nortel CallPilot
1005r Server Maintenance and Diagnostics
NN44200-704 01.06 Standard
5.0 19 July 2007