Nortel CallPilot User Manual page 100

100 Chapter 9 RAID operations
10
11
12
13
14
15
16
17
18
19
20
21
22
Copyright © 2007, Nortel Networks
.
From the Configure menu, select New Configuration. Click Yes
to proceed.
Result: The system displays the SCSI channel with two drives.
SCSI IDs are automatically assigned for each of the two drives. All
disk drives must be in READY state.
Note: Do not use the Load command on the Configure menu.
This command is not for RAID operations.
Create the logical drive by selecting Channel-1 A01-0 and pressing
the spacebar.
Result: The display changes to ONLIN A01-01.
Select A01-02 and press the Spacebar.
Note: The drives blink when you select them.
Press Enter to End the Array.
Result: The blinking stops.
Press F10 to configure the logical drive.
Press the spacebar to select Configuration Array.
Result: Span-1 appears in the box opened for the A01 logical drive.
Press F10 to configure the logical drive.
Result: The system prompts you for the logical drive to consecutively
select:
RAID 1;
Size: accept the size displayed
Accept
SPAN = NO
Change the last value to NOSPAN, if required.
Select Accept and press Enter to accept these new values.
Result: The system prompts you to save the configuration.
Select YES and press Enter.
Result: The configuration is saved. Press any key to continue.
Press ESC to exit the submenus.
In the Management menu, choose the Initialize submenu.
Press F2 to select the logical drive.
Press F10 and consecutively select YES to initialize the drive pack.
Nortel CallPilot
1005r Server Maintenance and Diagnostics
NN44200-704 01.06 Standard
5.0 19 July 2007