Nortel CallPilot User Manual page 120

120 Chapter 10 Replacing or adding voice processing boards
20
21
22
23
24
25
26
27
Copyright © 2007, Nortel Networks
.
PCI riser assembly rear studs and slots
Reconnect the DS30X cable or cables to the MPB96 card or cards.
You must reconnect each cable to the same MPB96 card it was
previously connected to. Use the labels you applied as a guide.
Replace the chassis cover.
Take the ESD strap off.
Power up the server and log on to Windows.
Result: The Windows New Hardware Found Wizard screen appears.
Click Next.
Select the presented Nortel MPB driver (there is only one).
Run the Configuration Wizard to configure the new hardware.
For instructions, see Meridian 1 and CallPilot Server Configuration
(NN44200-302) or CS1000 and CallPilot Server Configuration
(NN44200-312).
Result: The MPB96 board replacement is complete.
Test the multimedia channels to ensure the new MPB96 board is
functioning properly.
For instructions, see "Testing the CallPilot installation" in the
Installation and Configuration Task List (NN44200-306).
Nortel CallPilot
1005r Server Maintenance and Diagnostics
NN44200-704 01.06 Standard
5.0 19 July 2007