Upgrading To High Capacity; Nortel Callpilot; 1005R Server Maintenance And Diagnostics; Nn44200-704 01.06 Standard - Nortel CallPilot User Manual

Upgrading to high capacity

This section describes how to upgrade your server hardware to the high
capacity configuration. You need three MPB96 boards to support the high
capacity feature.
MPB96 boards are not hot-swappable and you must power down the system
before adding boards.
Requirements
•
•
To add two MPB96 boards
Step
1
2
3
4
5
Copyright © 2007, Nortel Networks
.
CAUTION
Risk of electrical damage
•
Wear an antistatic ESD wrist strap when handling cards
or boards, or when working inside the server.
• Do not touch the components or gold-edge connectors
of cards or boards.
• Place the board on an antistatic surface until you are
ready to install it.
Phillips (cross head) screwdriver, #1 and #2 bit
High capacity upgrade kit (includes two MPB96 boards, a CT bus cable,
and two DS30X cables)
Action
Courtesy stop all CallPilot channels. Refer to
components" (page
Power down the server, unplug all peripheral devices and ethernet
cables, and disconnect the AC power.
Attach the ESD strap to your wrist and attach the other end to a
known grounded connection.
Remove the chassis cover. Refer to
server cover" (page 75)
Disconnect the red power cable from the PCI riser assembly.

Nortel CallPilot

1005r Server Maintenance and Diagnostics

NN44200-704 01.06 Standard

5.0 19 July 2007
Upgrading to high capacity 121
—End—
53).
"Removing and replacing the
for instructions.
"Starting and stopping