PolyBlend
Model #PB50-0.4
INSTALLATION, OPERATION, AND MAINTENANCE INFORMATION
CONTENTS
Overview
Installation
Operation
Maintenance
READ THIS MANUAL BEFORE YOU
INSTALL, OPERATE, OR SERVICE THIS
UNIT.
OVERVIEW
SAFETY PRECAUTIONS
Ensure that the control panel is grounded to avoid
possible electrical shock or damage to equipment.
Before servicing, turn off all power and assure
power "lockout" to avoid possible electric shock.
Disconnect external power to the control panel
before removing or replacing fuses.
SPECIFICATIONS
Pump
Diaphragm
Inlet
1/2" FPT, Water Supply
5/8" Hose Barb, Polymer
Supply
Outlet
1/2" FPT, Solution Discharge
Water Capacity
50 GPH Primary
Polymer Capacity
0.42 GPH
Pressure Rating
100 PSI
Electrical Supply
120/1/60, 6 Amps
Dimensions
23" H x 10" W x 16" D
Weight
51 lbs.
Motor(s)
(1) 1/6 HP, 120VAC, 3.6 AMPS
WATER TECHNOLOGIES
P.O.BOX 389
BRADLEY, IL 60915
Warranty
Appendixes
Drawings
-1-
INSTALLATION
LOCATION
Select a location that provides:
•
Electrical Supply
•
Potable Water (Clean)
•
Proximity to the Point of Use
•
Easy Handling and Storage of Polymer
•
Access to Unit
•
Protection Against Severe Weather
UNPACKING
Examine package contents for damage. Report any to
freight forwarder.
Check plastic bag(s) for contents
against individual packing list(s).
NOTE: Disregard any moisture; this unit was
wet tested.
CONNECTIONS
•
Use Teflon tape on threads. Use joint compound
(pipe dope) in small amounts, if necessary.
•
Do not over-tighten fittings.
•
Insure that supply water pressure is less than 100
psi.
•
Install water isolation valve with unions.
•
Insure that neat polymer feed line has a flooded
suction.
NOTE: To enhance performance, reduce the
number of piping turns and elevation changes.
STORAGE
Store in atmosphere controlled environment. Protect
from extreme temperature (above 110°F, 52°C, below
32°F, 0°C) and wide ambient temperature fluctuations.
Protect from direct weather exposure, i.e., sun, rain,
high wind, etc.
TELEPHONE
815-932-8154
800-882-6466
FACSIMILE
815-939-9845