Rear Differential Inspection; Specifications; Tightening Torque Specifications - Suzuki Grand Vitara 2011 Manual

3B-37 Differential: Rear
26) Assembly rear drive left retainer in the same manner
at Step 25) in this assembly procedure.
27) Clean mating surface of right retainer, carrier (1) and
rear cover (2), apply sealant to carrier and rear cover
as shown in figure by such amount that its section is
1.5 mm (0.059 in.) in diameter, mate right retainer
with carrier and rear cover, and then tighten bolts to
specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Retainer bolt: 50 N·m (5.0 kgf-m, 36.5 lb-ft)
2

Tightening Torque Specifications

Fastening part
Rear differential front mounting bolt
Rear differential rear mounting bolt
Bevel gear bolt
Rear cover bolt No.1
Rear cover bolt No.2
Retainer bolt
NOTE
The specified tightening torque is also described in the following.
"Rear Differential Unit Components: Rear"
"Rear Differential Components: Rear"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fastener Information in Section 0A".
28) Clean mating surface of left retainer, carrier (1) and
"A"
29) Install rear drive right and left shaft using plastic
1
I5JB0A321048-01

Rear Differential Inspection

Refer to "Front Differential Inspection: Front".

Specifications

Tightening torque
N⋅m
120
120
200
50
60
50
rear cover (2), apply sealant to carrier and rear cover
as shown in figure by such amount that its section is
1.5 mm (0.059 in.) in diameter, mate left retainer with
carrier and rear cover, and then tighten bolts to
specified torque.
"A": Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Retainer bolt: 50 N·m (5.0 kgf-m, 36.5 lb-ft)
1
hammer.
kgf-m lb-ft
12.0 87.0
12.0 87.0
20.0 145.0
5.0 17.0
6.0 43.5
5.0 36.5
2
"A"
I5JB0A322014-01
S6JB0A3226006
S6JB0A3227001
Note
/