Suzuki Grand Vitara 2011 Manual page 851

5) Remove coil assembly (1) from rotor (2) and then
remove wave washer (3).
2
6) Hold rotor by using vise (2) and loosen pulley nut (6)
and then remove pulley (1).
CAUTION
!
When using vise, put clean cloth (3) and
aluminium plate (5) between rotor (4) and
vise (2) so as not to cause damage to rotor.
6
1
5
2
Assembly
1) Insert rotor assembly to drive end frame and then
install pulley (1).
2) Install pulley nut (6) and then tighten pulley nut.
CAUTION
!
When using vise, put clean cloth (3) and
aluminium plate (5) between rotor (4) and
vise (2) so as not to cause damage to rotor.
6
1
5
2
1
3
I5JB0B1A0013-01
3
5
2
4
I5JB0B1A0014-01
3
5
2
4
I5JB0B1A0014-01
Charging System: For Diesel Engine Model 1J-25
3) Install wave washer (3) and coil assembly (2) to rotor
(1).
NOTE
With marks on drive end frame and coil
assembly marked before remove aligned to
each other.
2
4) Install through bolt and then tighten through bolt (1).
1
5) Install brush holder assembly to coil assembly as
follows.
a) Depress brush (1) and then while holding it
depressed, and insert pin (2).
1
b) Install brush holder assembly (1) to coil
assembly (2) and then tighten screw (3).
2
3
1
3
I5JB0B1A0013-01
1
I5JB0B1A0016-02
2
I5JB0B1A0017-01
1
I5JB0B1A0030-01