Automatic Transmission Assembly Dismounting And Remounting - Suzuki Grand Vitara 2011 Manual

5A-103 Automatic Transmission/Transaxle:
Automatic Transmission Assembly
Dismounting and Remounting
Dismounting
1) Dismount engine with transmission and transfer
referring to "Engine Assembly Removal and
Installation: For J20 Engine in Section 1D".
2) Disconnect connectors from output shaft speed
sensor, input shaft speed sensor, transmission range
sensor, transmission wire, transfer actuator,
differential lock switch and 4L/N (if equipped) switch
release their wire harnesses from clamps.
3) Remove transfer (for 4WD model) or extension case
assembly (for 2WD model) from transmission
referring to "Transfer Assembly Dismounting and
Remounting: Motor-Shift Type (Transfer with Shift
Actuator) in Section 3C" (for 4WD model) or
"Extension Case Assembly Removal and
Installation: For Petrol Engine Model in Section 5B"
(for 2WD model).
4) Remove engine earth cable.
5) Remove engine rear mounting member and rear
mounting referring to "Engine Mountings
Components: For J20 Engine in Section 1D".
6) Remove oil filler tube.
7) Remove cooler hose.
8) Remove drive plate cover, and then remove drive
plate bolts by holding crankshaft pulley bolt
stationary.
9) Remove Starting Motor referring to "Starting Motor
Dismounting and Remounting: For Petrol Engine
Model in Section 1I".
10) Remove transmission assembly from engine
assembly.
Installation
For remounting, reverse dismounting procedure noting
the following points.
S6JB0A5106028
• Tighten each bolts and nuts referring to "Automatic
Transmission Unit Components"
• Tighten drive plate bolt No.1 (1) first and then tighten
drive plate bolts No.2 (2).
• Set each clamp for wiring securely.
• Fill A/T fluid referring to "A/T Fluid Change".
• Connect battery and check function of engine and
transmission.
2
1
I5JB0A510068-01