Dtc Table - Suzuki Grand Vitara 2011 Manual

DTC Check
1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(1).
Special tool
(A): SUZUKI scan tool
(A)

DTC Table

CAUTION
!
Be sure to perform "Electronic Stability Program Check" before starting diagnosis.
DTC
(displayed
Diagnostic Items
on SUZUKI
scan tool)
NO DTC Normal
Longitudinal G sensor in
C1015 yaw rate / G sensor
assembly failure
C1016 Stop light switch failure
Lateral G sensor in yaw rate
C1017
/ G sensor assembly failure
Brake fluid level switch
C1018
failure
Master cylinder pressure
C1020
sensor power supply failure
C1021 RF
C1025 LF Wheel speed
C1031 RR sensor circuit failure
C1035 LR
C1022 RF
Wheel speed
C1026 LF
sensor or encoder
C1032 RR
failure
C1036 LR
3) Turn ignition switch to ON position.
S6JB0A4604005
4) Read DTC according to instructions displayed on
SUZUKI scan tool and print it or write it down. Refer
to SUZUKI scan tool operator's manual for further
details.
NOTE
If SUZUKI scan tool can not communicate
ESP® control module, perform "Serial Data
Link Circuit Check".
5) After completing the check, turn ignition switch off
and disconnect SUZUKI scan tool from DLC.
1
I5JB0A450008-01
Detecting condition (DTC will be
set when detecting)
—
Longitudinal G sensor signal is out of
specified range. (for 4WD vehicle)
Vehicle behavior and stop light
switch signal is disagreed for
specified time.
Lateral G sensor signal is out of
specified range.
• Brake fluid level is too low.
• Input voltage of brake fluid level
switch to BCM is low.
Power supply voltage to master
cylinder pressure sensor in ESP®
hydraulic unit / control module
assembly is too low.
Wheel sensor signal is out of
specified range.
Abnormal wheel speed sensor signal
is detected.
Electronic Stability Program:
ABS EBD
warning warning
light light
— —
—
— —
— —
— —
— —
*1
*1
4F-13
S6JB0A4604006
ESP®
warning
light
—
—