Suzuki Grand Vitara 2011 Manual page 1078

3D-4 Propeller Shaft:
2) Using snap ring plier (1), remove 2 circlips.
3) Using special tool, push spider bearing race out 3 –
4 mm (0.12 – 0.16 in.) from shaft yoke race.
NOTE
Before pushing it out, apply penetrate
lubricant between bearing race (1) and yoke
race (2).
Special tool
(A): 09926-48010
Spider bearing race installing position (length
"a")
"a": 3 – 4 mm (0.12 – 0.16 in.)
4) Tapping yoke with a hammer, completely remove
bearing race.
5) Take out bearing race on the other side in the same
way as in Step 3) and 4).
I5JB0A340005-02
6) Push out bearing race on flange yoke side as
described in Step 2) and 3), and then, holding
bearing race in a vise (1), tap flange yoke and take
out race. (Refer to the figure.)
Remove bearing race on the opposite side in the
same way.
NOTE
• Take care not to lose rollers in spider
bearing race when removing it.
• Fit removed bearings temporarily in spider
so that they can be reinstalled in their
original positions.
I5JB0A340006-01
IYSQ01340007-01
IYSQ01340008-01