Front Wheel Encoder On-Vehicle Inspection - Suzuki Grand Vitara 2011 Manual

4E-42 ABS:
5) Remove rear wheel speed sensor (3) from knuckle.
CAUTION
!
• Do not pull wire harness when removing
rear wheel speed sensor.
• Do not cause damage to surface of rear
wheel speed sensor and do not allow dust,
etc. to enter its installation hole.
3
Installation
Reverse removal procedure for installation noting the
following.
• Check that no foreign material is attached to sensor
(1) and mating encoder (2).
• Be sure to install wheel speed sensor (1) and its bolt
at the correct (upper) position as shown in figure.
Tighten sensor bolt and harness clamp bolts to
specified torque.
Tightening torque
Rear wheel speed sensor bolt (a): 11 N·m (1.1 kgf-
m, 8.0 lb-ft)
Rear wheel speed sensor harness clamp bolt
(b): 11 N·m (1.1 kgf-m, 8.0 lb-ft)
CAUTION
!
Do not pull or twist wire harness more than
necessary when installing rear wheel speed
sensor.
• Check that there is no clearance between sensor and
brake back plate.
4
1
2
I5JB0A450032-02

Front Wheel Encoder On-Vehicle Inspection

Before inspect front wheel encoder, remove front drive
shaft or front wheel spindle referring to "Front Drive Shaft
Assembly Removal and Installation: Front in Section 3A"
or "Front Wheel Hub Assembly Removal and Installation
in Section 2B".
• Check encoder (1) for being crack, damaged or
deformed.
• Turn wheel and check if encoder rotation is free from
eccentricity and looseness.
• Check that no foreign material is attached.
If any faulty is found, repair or replace. Refer to "Front
Wheel Hub Assembly Removal and Installation in
Section 2B".
(a)
1
2
[A] [B]
1
[A]: OK [B]: NG
1
(b)
1
I5JB0A450033-01
S6JB0A4506010
I5JB0A450034-01