Suzuki Grand Vitara 2011 Manual page 1068

3C-83 Transfer: Non-Shift Type (Transfer without Shift Actuator)
12) Remove front drive sprocket bush (1) from rear
output shaft (2).
13) Take out front drive sprocket (1), front output shaft
assembly (2), drive chain (3) and needle bearing (4)
from rear case (5) all at once.
1
4
14) Remove snap ring (1), and then rear output shaft
assembly (2) from rear case (3).
1
15) Remove rear oil seal (1) from rear case (2) using flat
end rod or the like, if necessary.
1
2
I5JB0A331023-01
2
5
3
I5JB0A331024-01
2
3
I5JB0A331025-01
1
2
I5JB0A331026-01
16) Remove needle bearing (1) from rear case (2) using
special tool, if necessary.
Special tool
(A): 09913–76010
17) Remove input gear plate (1), and then remove input
gear assembly (3) from front case (2).
1
3
18) Remove front oil seal No.2 (1) from front case (2)
using flat end rod or the like, if necessary.
Reassembly
1) Install front oil seal No.2 to front case (1) using
special tool, and then apply grease to oil seal lip.
: Grease 99000–25010 (SUZUKI Super Grease A)
Special tool
(A): 09913–85210
(A)
1
2
I5JB0A331027-01
2
I5JB0A331091-01
1
2
I5JB0A331030-01
(A)
1
I5JB0A331033-01