Suzuki Grand Vitara 2011 Manual page 976

3B-31 Differential: Rear
9) Install special tools with bearings (3) and flange (2)
to differential carrier (1).
NOTE
This installation requires no spacer or oil
seal.
Special tool
(E): 09951–46010
(F): 09926–78311–002
10) Tighten flange nut (1) so that specified bearing
preload is obtained.
NOTE
• Before taking measurement with spring
balance (2) or torque wrench (3), check for
rotation by hand and apply small amount
of differential oil to bearings.
• On measuring preload, rotate the drive
bevel pinion about 1 rotation per 2
seconds.
Special tool
(C): 09922–75222
(F): 09926–78311–002
Pinion bearing preload
0.9 – 1.7 N⋅m (9.0 – 17.0 kg-cm, 7.8 – 14.7 lb-in.)
Spring measure reading with special tool
20 – 40 N (2.0 – 4.0 kg, 4.4 – 8.8 lb)
4. Socket with adapter
11) Set dial gauge to mounting dummy and make 0
(zero) adjustment on surface plate (1).
NOTE
• When setting dial gauge to mounting
dummy, tighten screw (2) lightly. Be careful
not to overtighten it, which will cause
damage to dial gauge.
• With dial gauge set, turn dummy back and
force by hand a couple of times and attain
accurate 0 (zero) adjustment.
• It is desirable that short pointer indicates
beyond 2 mm when long one is at 0 (zero).
Special tool
(A): 09900–20607
(B): 09926–78320
I5JB0A321030-01
I5JB0A321031-01
IYSQ01322033-01