Suzuki Grand Vitara 2011 Manual page 1099

3) Take out fluid with syringe or such.
4) Disconnect clutch reservoir hose (1) from reservoir
(2) (M/T model).
1
5) Remove reservoir connector pin (1) by using special
tool and then reservoir.
Special tool
(A): 09916–44310
(A)
1
Installation
1) Lubricate new grommets with the same fluid as the
one to fill reservoir (1) with. Then press-fit grommets
(3) to master cylinder (2). Grommets (3) must be
seated in place.
3
2
I5JB0A410012-02
I5JB0A410013-02
1
3
2
I5JB0A410014-01
Brake Control System and Diagnosis:
2) Install reservoir (1) and drive in reservoir connector
pin (2) by using special tool (A). till both of its ends at
the right and left of reservoir becomes the same
length.
Special tool
(A): 09916–44310
3) Connect clutch reservoir hose (1) to reservoir (2) (M/
T model).
1
4) Connect reservoir lead wire at coupler.
5) Fill reservoir with specified fluid.
6) After installing, bleed air from brake system referring
to "Air Bleeding of Brake System" and at the same
time bleed air from clutch system referring to "Air
Bleeding of Clutch System in Section 5C" (M/T
model).
7) Upon completion of installation, check for fluid
leakage.
4A-14
I5JB0A410015-01
2
I5JB0A410012-02