Table of Contents
Advertisement
9.
Tighten the captive screws at the top and bottom of the SFB by hand or with a Phillips screwdriver
(see
Figure 79 on page
Figure 79: Tighten the Captive Screws on the SFB
10. Install the appropriate fan tray (see
11. Set the fans to normal speed using the test chassis fan tray speed 0 normal and test chassis fan tray
speed 1 normal command.
12. Bring the SFB online using the request chassis sfb slot
You can check the status of the SFB using the show chassis sfb and the show chassis fabric summary
commands.
NOTE: If you completely powered off the SFB using the set chassis sfb
command, you must delete the configuration to bring the SFB online. To delete the
configuration and bring a replacement SFB online, use the delete chassis sfb
offline command.
Remove an MX10004 Switch Fabric Board
A Juniper Networks MX10004 router has up to six Switch Fabric Boards (SFBs) that are located in the
middle of the chassis behind the fan trays. SIB 0 through SIB 2 are located behind the left fan tray and
180).
"Install an MX10004 Fan Tray" on page
164).
slot-number online command.
slot-number offline
slot-number
180
Advertisement
Table of Contents
