Mx10004 Cable Specifications For Console And Management Connections - Juniper MX10004 Hardware Manual

third-party optical module or cable and, if required, replace it with an equivalent
Juniper-qualified component.
Use of third-party optical modules with high-power consumption (for example,
coherent ZR or ZR+) can potentially cause thermal damage to or reduce the lifespan of
the host equipment. Any damage to the host equipment due to the use of third-party
optical modules or cables is the users' responsibility. Juniper Networks will accept no
liability for any damage caused due to such use.
MX10004 Cable Specifications for Console and Management
Connections
Table 37 on page 96 lists the specifications for the cables that connect the MX10004 router to a
management device.
NOTE: You can configure the MX10004 with small form-factor pluggable (SFP) management
ports that support 1000BASE-SX transceivers.
Table 37: Cable Specifications for Console and Management Connections for the MX10004 Routers
Port on MX10004 Cable Specification
Router
Console port RS-232 (EIA-232) serial
cable
Management port Category 5 cable or
equivalent suitable for
1000BASE-T operation
Cable Supplied
One 7-foot (2.13-meter)
long RJ-45 patch cable
and RJ-45 to DB-9
adapter
One 7-foot (2.13-meter)
long RJ-45 patch cable
Maximum Device
Length Receptacle
2.13 meters RJ-45
100 meters RJ-45
96