Table of Contents
Advertisement
2.
Make sure that the voltage across the DC power source cable leads is 0 V.
3.
Ensure that the black power supply output switch, to the right of the captive screw, is set to the
standby position.
4.
Unscrew the captive screw counterclockwise using the Phillips (+) screwdriver, number 1. (See
Figure 65 on page 162
Figure 65: Remove a JNP10K-PWR-DC2 Power Supply on an MX10004
5.
Rotate the captive screw away from the faceplate of the power supply to release the latch.
)
162
Advertisement
Table of Contents
