Table of Contents
Advertisement
recommend that you not mix DIP switch settings in your system. See
information about the input and output voltages when you use the DIP switches.
The JNP10K-PWR-AC2 power supply has internal fans that contribute to chassis cooling. Consequently,
all three power supplies must be present in a running chassis to provide adequate airflow. While all
power supplies are required to be present in the chassis, they do not all need to be connected to power.
If a power supply is installed in a slot but not connected to a power source, it draws power from the
chassis to power the internal fans in the power supplies.
Figure 19: JNP10K-PWR-AC2 Power Supply
WARNING: Extreme burn danger! Do not handle an HVAC or HVDC power supply
running in the chassis without heat-protective gloves, such as welder's gloves. The
JNP10K-PWR-AC2 can reach temperatures in the range of 158° F to 176° F (70° C to
80° C) under running conditions.
WARNING: The router is pluggable type A equipment installed in a restricted-access
location. It has a separate protective earthing terminal on the chassis that must be
connected to earth ground permanently to ground the chassis adequately and protect
the operator from electrical hazards.
CAUTION: Before you begin installing the router, ensure that a licensed electrician has
attached an appropriate grounding lug to the grounding cable that you supply. Using a
grounding cable with an incorrectly attached lug can damage the router.
Table 11 on page 40
for
39
Advertisement
Table of Contents
