5. Slide the transceiver in gently until it is fully seated.
6. Remove the rubber safety cap when you are ready to connect the cable to the transceiver.
LASER WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
Figure 101: Install an SFP Transceiver
Figure 102: Install a QSFP+, QSFP28, or QSFP56-DD Transceiver
Remove a Transceiver from an MX10004 Line Card
Before you begin to remove a transceiver from the MX10004 line card, ensure that you have taken the
necessary precautions for safe handling of lasers (see
on page
253).
"Laser and LED Safety Guidelines and Warnings"
207