Handle And Store Routing And Control Boards Properly; Handle A Routing And Control Board Properly; Store A Routing And Control Board In An Electrostatic Bag - Juniper MX10004 Hardware Manual

Handle and Store Routing and Control Boards Properly

SUMMARY
This topic will explain how to handle an RCB when
you are installing or after removing an RCB. It also
explains how store the RCB.

Handle a Routing and Control Board Properly

Pay attention to the way you handle a Routing and Control Board (RCB). You install RCBs horizontally. It
is best to hold them by the sides when they are not in the chassis, to prevent damage to the connectors.
To handle an RCB properly:
1. Orient the RCB so that the faceplate is toward you.
2. Grasp each side of the unit firmly as you slide the unit out of the chassis.
3. Take care not to strike the unit against any object as you carry it.
CAUTION: Never hold the RCB by the connector edge. The connectors are fragile and
the RCB will not seat properly if one or more of the connectors are damaged.
4. If you must rest an RCB on an edge, place a cushion between the edge and the surface.
CAUTION: Do not stack RCBs on top of one another or on top of any other
component.
5. Place each RCB in an individual antistatic bag or separately on an antistatic mat that is placed on a
flat, stable surface.

Store a Routing and Control Board in an Electrostatic Bag

You must store Routing and Control Boards (RCBs) either in the chassis or in a spare shipping container,
horizontally and sheet-metal side down. Do not stack these units on top of one another or on top of any
other component. Place each unit separately in an antistatic bag or on an antistatic mat placed on a flat,
stable surface.
IN THIS SECTION
Handle a Routing and Control Board
Properly | 186
Store a Routing and Control Board in an
Electrostatic Bag | 186
186