Remove An Mx10004 Fan Tray Controller - Juniper MX10004 Hardware Manual

2. Carefully slide the fan tray controller into the fan tray controller slot until it is flush with the
mounting holes. See
Figure 71: Install the MX10004 Fan Tray Controller
3. Tighten the captive screws for the fan tray controller by hand or with a Phillips screwdriver.
4. Reinstall the fan tray. See

Remove an MX10004 Fan Tray Controller

For each of the two fan trays, there is a JNP10004-FTC2 fan tray controller. Each fan tray controller is a
hot-removable and hot-insertable field-replaceable unit (FRU); you can remove and replace one fan tray
Figure 71 on page 170.
"Install an MX10004 Fan Tray" on page 164.
170