Table of Contents
Advertisement
Each fan tray is installed vertically on the rear, or FRU side, of the chassis.
To install an MX10004 fan tray:
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist and connect the other
end of the strap to one of the ESD points on the chassis (see
Figure 67: ESD Point on the Rear of the MX10004
ESD point
1
—
2. Grasp the top and bottom fan tray handles and align the fan tray so that it makes contact with the
side wall.
3. Push the fan tray into place until it is fully seated.
Figure 67 on page
165).
165
Advertisement
Table of Contents
