Juniper MX10004 Hardware Manual page 53

Table 14: Physical Markings on Chassis Versus show chassis power Command
Physical Marking on JNP10K-PWR-AC2
INP2
Table 15 on page 43 describes the LEDs on a JNP10K-PWR-AC2 power supply.
Table 15: JNP10K-PWR-AC2 LEDs on an MX10004
LED
INP1
1 or ( in CLI output)
INP2
2 or ( in CLI output)
OK (Power OK)
! (Fault)
Color State
Yellow Blinking
Green Solid
Unlit Off
Yellow Blinking
Green Solid
Unlit Off
Green Solid
Yellow Blinking
Red Solid
Unlit Off
(Continued)
show chassis power Command
INP2
Description
The input voltage is present, but a fault is
detected.
The power supply is functioning properly.
The power supply is switched off; voltage is zero.
The input voltage is present, but a fault is
detected.
The power supply is functioning properly.
The power supply is switched off; voltage is zero.
The power supply is functioning properly.
The power supply output has detected a fault.
The power supply has failed and must be
replaced.
The power supply is functioning normally.
43