Table of Contents
Advertisement
MX10004 Power Cable Specifications
IN THIS SECTION
JNP10K-PWR-AC2 Power Cable Specifications | 44
JNP10K-PWR-AC2 Power Cable Specifications for 30-A Input | 47
Most sites distribute power through a main conduit that leads to frame-mounted power distribution
panels, one of which can be located at the top of the rack that houses the router. An AC power cord
connects each power supply to the power distribution panel.
NOTE: In North America, AC power cords must not exceed 15 feet (approximately 4.5 meters) in
length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and
210-52 and with Canadian Electrical Code (CEC) Section 4-010(3). The cords shipped with the
router to North America and Canada are in compliance.
The MX10004 AC, high-voltage alternating current (HVAC), and high-voltage direct current (HVDC)
power supplies have specific cord requirements. Use the following sections to determine the cable
requirements based on the model of your power supply and any mode settings:
• For JNP10K-PWR-AC2 with 20-A input, see
page
44.
• For JNP10K-PWR-AC2 with 30-A input, see
A Input" on page
47.
JNP10K-PWR-AC2 Power Cable Specifications
The JNP10K-PWR-AC2 power supply operates in two modes:
• 20-A input with 3000-W output; see
• 30-A input with 5500-W output; see
on page 47
for a list of appropriate cables and connectors for 30-A input.
WARNING: Do not run JNP10K-PWR-AC2 power supplies using 16-A or 20-A cables if
connected to 30-A input.
"JNP10K-PWR-AC2 Power Cable Specifications" on
"JNP10K-PWR-AC2 Power Cable Specifications for 30-
Table 16 on page 45
for a list of appropriate cables.
"JNP10K-PWR-AC2 Power Cable Specifications for 30-A Input"
44
Advertisement
Table of Contents
