Management Port Pinouts For The Mx10004 Router - Juniper MX10004 Hardware Manual

• RE-USB-4G-S—4-GB USB flash drive
CAUTION: Any USB memory product not listed as supported for the MX10004 router
has not been tested by Juniper Networks. The use of any unsupported USB memory
product could expose your device to unpredictable behavior. The Juniper Networks
Technical Assistance Center (JTAC) can provide only limited support for issues related to
unsupported hardware. We strongly recommend that you use only supported USB flash
drives.
CAUTION: Remove the USB flash drive before upgrading Junos OS or rebooting an
MX10004 router. Failure to do so could expose your device to unpredictable behavior.
NOTE: USB flash drives used with the MX10004 router must support USB 2.0 or later.

Management Port Pinouts for the MX10004 Router

The 1000BASE-T RJ-45 management ports use an RJ-45 connector to connect to one of these points:
• The control plane and management network in an MX10004 router
• A management device for out-of-band management
Table 40 on page 103 provides the pinout information of the RJ-45 management port connector. An
RJ-45 cable is supplied with the MX10004 router.
Table 40: RJ-45 Management Port Connector Pinouts for the MX10004 Router
Pin
1
2
3
Signal
TRP1+
TRP1–
TRP2+
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
103