4.3
Connecting up the system unit
Figure 4: Connecting the monitor, keyboard and mouse to the system unit
When you are making the connections between the system unit and the
!
peripherals, the devices must not be plugged into the power.
All cables and lines must be routed in such a way that no-one can tread
on them or trip over them.
To tighten the securing screws on the cable connectors you will need a small
flathead screwdriver and a small crosspoint screwdriver.
Attaching the mouse
If you want to use your system in full graphics mode you have to connect the mouse.
Plug the round 6-pin connector on the mouse connecting cable into the 6-pin
Ê
socket labeled Mouse on the system unit backplane.
The arrow on the cable connector must be at the top as you push the connector
into the socket.
U24802-J-Z146-2-7600
Installing the system unit
RM400 C Models
4
27