Cleaning The Cd-Rom Drive; Cleaning Cartridge Tape Drives - Siemens RM400 C Series Operating Manual

Table of Contents

Advertisement

12
Equipment care

12.1.2 Cleaning the CD-ROM drive

The CD-ROM does not require any special cleaning.

12.1.3 Cleaning cartridge tape drives

The intervals at which you need to clean the cartridge tape drives are based on the
length of time they are in use, the quality of the tapes and the environmental condi-
tions.
Inadequate cleaning or none at all increases the read/write error rate and causes
accelerated wear to the tape materials and the head drums, even to the extent of
particles of dirt being burnt into the head drum. If particle burn-in occurs, the
problem cannot simply be solved by using a cleaning cartridge. You then need to
send the drive to the SNI Service Center for cleaning and inspection.
Always clean the read/write head after using a new tape, because tape
i
abrasion may lead to read/write errors.
Cleaning the quarter-inch cartridge tape drive
Clean the read/write head of the quarter-inch cartridge tape drive with the appro-
priate cleaning kit at the following intervals:
in use eight hours per day:
used briefly every day:
used once per week:
Cleaning the 4 mm cartridge tape drive
Clean the read/write head of the 4 mm cartridge tape drive, using only the appro-
priate cleaning cartridge, at the following intervals:
in use five to six hours per day:
in use three to four hours per day:
in use no more than two hours per day:
If the error indicator flashes, you must clean the drive immediately to
!
prevent damage from dust particles.
142
clean twice a week
clean once a week
clean every two weeks
RM400 C Models
clean every day
clean once a week
clean every month
U24802-J-Z146-2-7600

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rm400 c60Rm400 c62Rm400 c70Rm400 c72Rm400 c80Rm400 c90

Table of Contents