Closing The Peripherals Cabinet - Siemens RM400 C Series Operating Manual

6.7.2

Closing the peripherals cabinet

When you have finished, replace the door or the back cover of the peripherals
cabinet:
Replacing the door on the front of the RM400 BG31/32 peripherals cabinet
Lift the door into the groove at the bottom of the front of the peripherals cabinet
Ê
and press it against the cabinet until it latches into place.
Turn the keyswitch on the operator panel of the RM400 BG31/32 peripherals
Ê
cabinet to the right, into the vertical position.
The door is now locked.
Replacing the back cover of the RM400 BG31/32 peripherals cabinet
Ê Lift the back cover into its groove at the bottom of the peripherals cabinet and
press it against the cabinet until it latches into place.
Ê Secure the back cover by inserting a T20 Torx screwdriver or a 4 mm slit screw-
driver into the hole in the release button (as shown in the left-hand diagram in
figure 44 on page 74) and turn the screw anti-clockwise until it is tight.
U24802-J-Z146-2-7600
Online replacement (OLR)
RM400 C Models
6
75