Gear Units With Cooling Coil; Gear Unit With Add­on Components; Gear Units With Add­on Air Oil­cooler; Gear Units With Add­on Water Oil­cooler - Siemens FLENDER H SH Series Assembly And Operating Instructions Manual

6.13

Gear units with cooling coil

• Before connecting the cooling coil the screw plugs must be removed from the connecting bushes.
• Flush the cooling coil (in order to remove any contamination).
• Connect the cooling­water in­ and outflow pipes (for exact position of the connections,
see dimensioned drawing).
Observe also item 5.10.2.
6.14 Gear unit with add­on components
• For the technical data to the add­on components, as stated in item 6.15 to 6.20, refer to the
order­specific list of equipment.
The electrical equipment for regulation and control must be wired in accordance with
the equipment suppliers' instructions.
For operation and maintenance the operating instructions provided specifically for
the order and the specifications in items 5.10.2 to 5.13 must be observed.
6.15 Gear units with add­on air oil­cooler
• Wire the contamination indicator for switchover filter (for gear sizes $$ 13) and pressure monitor
electrically.
• Wire the fan motor electrically.
Observe also item 5.10.3.
6.16 Gear units with add­on water oil­cooler
• Before connecting the water oil­cooler remove the sockets from the cooling­water connections.
• Flush the water oil­cooler (in order to remove any contamination).
• Install the cooling­water in­ and outflow pipes (for flow direction and exact position of connections,
see dimensioned drawing).
Make sure when installing the piping that no forces, moments or vibrations act upon
the connections of the water oil­cooler.
• Wire the pressure monitor electrically (in case of gear units with corresponding equipment only).
Observe also item 5.10.4.
6.17 Gear unit with oil­temperature monitoring system
• Wire the resistance thermometer with evaluating instrument (to be provided by customer) electrically.
6.18 Gear unit with oil­level monitoring
• Wire the level­limit switch electrically.
6.19 Bearing­monitoring system
• The bearing-monitoring device must be fitted by the customer.
6.20

Gear unit with speed transmitter

• Wire the speed transmitter electrically.
BA 5030 en 02/2013
69 / 96